water tube boiler specification

Characteristics of boiler feedwater - Lenntech

Feed-water purity requirements therefore can vary widely. A low-pressure fire-tube boiler can usually tolerate high feed-water hardness with proper treatment while virtually all impurities must be removed from water used in some modern, high-pressure boilers. Only relatively wide ranges can be given as to maximum levels of alkalis, salt, silica, phosphates etc, in relation to working pressure. The actual maximum levels must be obtained fro the boiler manufacturer, who will base them on the

Learn More

Scotch Marine (Fire Tube ) Boilers | Hurst Boiler

SCOTCH MARINE (FIRE TUBE) BOILERS Our two-pass, three-pass or four-pass Scotch Marine(Fire Tube) boilers are available in dryback, wetback, steam or hot water versions; from 15 to 800 hp with pressures to 300 psig. Hurst Scotch Marine boilers are rated to 81% minimum efficiency.

Learn More

Boiler Types and Classifications - Wiki - odesie by Tech Transfer

In a water-tube boiler ('''Figure 3'''), the water is inside the tubes and combustion gases pass around the outside of the tubes. The advantages of a water-tube boiler are a lower unit weight-per-pound of steam generated, less time required to raise steam pressure, a greater flexibility for responding to load changes, and a greater ability to

Learn More

ASTM International - Standards for Steel Pipes, Tubes and

The ASTM International specifications for steel tubes list standard requirements for boiler and super heater tubes, general service tubes, steel tubes in refinery service, heat exchanger and condenser tubes, mechanical and structural tubing.

Learn More

Section 23 52 33 - WATER-TUBE BOILERS

SECTION 23 52 33. WATER TUBE BOILERS. SPEC WRITER NOTES: 1.Delete between // // if not applicable to project. Also delete any other item or paragraph not applicable in the Section and renumber the paragraphs. 2.References to pressure in this section are gauge pressure unless otherwise noted.

Learn More

Standard Steam Boilers

Horizontal Water tube Boilers A wide selection of water tube boilers, all with double rows of tubes, are available. Not only have these boilers been well proven over the past two decades of hobby operation, but the influence of the local (Rhode Island) ALMY Boilers can be seen.

Learn More

Water Tube Boiler - Types, Working, Construction & Applications

Aug 28, 2019 · Water Tube Boiler is a high-pressure boiler that operates at a pressure of about 165 bar. Basically, in this boiler, water will be flown inside the tubes surrounded by flue gases. More steam is generated by using this boiler so, the overall efficiency of the boiler is high.

Learn More

Firetube Boilers - National Board of Boiler and Pressure

In a scotch boiler, the furnace is a large diameter tube, within the boiler, surrounded by water. Some older, large scotch boilers had two or three furnaces but modern boilers typically have only one. Scotch boilers may be two-pass, three-pass, or four-pass depending upon the arrangement of baffles and tubes.

Learn More

Water Tube Boiler Parts and Functions - Boilersinfo

In a typical Water tube boiler design as shown in the figure, it consists of two drums the steam drum and the water or mud drum. On this design straight tubes were rolled into mud drum, and the front headers were connected to the steam drum. The rear header was connected to a horizontal box header, which was also attached to the steam drum.

Learn More

Section 23 52 33 - WATER-TUBE BOILERS

SECTION 23 52 33. WATER TUBE BOILERS. SPEC WRITER NOTES: 1.Delete between // // if not applicable to project. Also delete any other item or paragraph not applicable in the Section and renumber the paragraphs. 2.References to pressure in this section are gauge pressure unless otherwise noted.

Learn More

specification of water tube boiler

specification of gas industrial boiler | Water Tube Takagis selection of residential and commercial tankless water heaters are unmatched for quality and diversity. Anywhere hot water is needed, Takagi provides an energy-efficient solution with long-lasting value for years after its installed.

Learn More

Boiler Water Quality

Boiler Water Quality Boiler Chemicals are used to ensure proper Boiler Water Quality in boilers. The below table is the Total Dissolved Solids or TDS, Alkalinity, and Hardness versus Boiler Pressure. First, knowing the water source is important, whether it is from ponds, rivers, ground wells, or city water.

Learn More

PROCESS DESIGN OF STEAM BOILERS (PROJECT STANDARDS AND

BOILERS (PROJECT STANDARDS AND SPECIFICATIONS) Page 3 of 45 Rev: 01 April 2011 SCOPE This Project Standards and Specifications is intended to cover minimum requirements for process design of field erected water tube boilers. REFERENCES Throughout this Standard the following dated and undated standards/codes are referred to.

Learn More

Boiler water Limit:- - Altret

Feed Water & Boiler water Characteristics as per IS:10392-1982 1.FEED WATER Parameters Upto 20 Kg/cm2 21 Kg/cm2 to 39 Kg/cm2 40 Kg/cm2 to 59 Kg/cm2 Unit Total Hardness <10 <1.0 <0.5 ppm as CaCO 3 pH Value 8.5-9.5 8.5-9.5 8.5-9.5 Dissolved Oxygen 0.1 0.02 0.01 As ppm Silica 5 0.5 As ppm SiO 2

Learn More

ASTM International - Standards for Steel Pipes, Tubes and

The ASTM International specifications for steel tubes list standard requirements for boiler and super heater tubes, general service tubes, steel tubes in refinery service, heat exchanger and condenser tubes, mechanical and structural tubing.

Learn More